Escea IB600 Installation Manual download pdf (Page 23)

630184_4 IB Installation Manual NZ

20.0 Fixing the Heater to the Base and Wall:

There are several ways that the heater can be fixed against movement: It is a requirement

that this heater be securely fastened to the wall and base.

Note: It is important that the outer fascia is used during this process to ensure that the

heater is located in the appropriate position within the cavity.

20.1 Fixing Heater to Base:

The heater has several holes along the front edge of the base panel that have been

provided to allow installers to screw the heater to the floor. Because of a lack of access for

drilling it may be necessary to mark the appropriate location for these screws and then

remove the heater and drill holes into hard flooring.

Alternatively a socket set can be used to drive in hex headed screws.

20.2 Fixing Heater to Wall:

The installer must also fix the heater to the sides of the cavity using the bracket

kit provided. These brackets must be installed over the outer lining

surface of the wall i.e. over the Plaster Board rather than

onto a stud which is then subsequently covered

with a wall lining. Otherwise the fire will be

sitting too far back and will inhibit

the outer fascia panel from

fitting correctly.

Install gas lines to

any of these 3 points.

Leave enough piping

to reach the front

right hand corner of

the ZCK once

installed.

Electrical

point of

entry.

Final gas connection point

(after ZCK installation)

Plan view from top looking down.

Gas pipe

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

No comments

Escea IB600 Installation Manual Page 23