Escea IB600 Installation Manual download pdf (Page 28)

630184_4 IB Installation Manual NZ

Step 6: Remove and discard the front and middle burners as

described in section 24.1 and 24.2 of this manual. To do this you

will need to detach the Spark Electrode Assembly.

If your fire is set to operate on Natural Gas, you will need to

remove the burner collars (shown right) from the removed

burners and attach them to the supplied burners, as described

in section 24.5 of this install manual.

Step 7: Install the burners supplied with your conversion kit and re-attach the Spark

Electrode Assembly. Ensure the Spark Electrode Assembly complies with the guidelines in

section 23.0 of this install manual. If using Natural Gas, remember to re-attach the burner

collar taken from the replaced burners and pictured above.

Step 8: Install the coal fuel bed as per section 21.3 of this installation manual.

22.2 Converting from Coals to Logs

Step 1: Remove the fascia and glass to provide access to the fuel bed if you have not

already done so. Remove and discard of the existing ceramic coals. Always ensure the

fireplace has cooled completely before attempting to access the firebox.

Step 2: Remove and discard the front and middle burners as described in section 24.1 and

24.2 of this manual. To do this you will need to detach the Spark Electrode Assembly.

If your fire is set to operate on Natural Gas, you will need to remove the burner collars

(shown top right of this page) from the removed burners and attach them to the supplied

burners, as described in section 24.5 of this install manual.

Step 3: Remove the firebox as described in section 17.0 of

this install manual.

Step 4: Once the firebox is removed, attach the Rear Log

Retainers using a screwdriver as shown right.

The IB600 and IB850 have 2x Rear Log Retainers, which

should be screwed in place in the rear corners of the

firebox. The IB1100 has 4x Rear Log Retainers, two in the

rear corners of the firebox and two in the center as shown.

Ensure brackets are facing upwards and in the orientation

shown to the right.

Step 5: Install the burners supplied with your conversion

kit and re-attach the Spark Electrode Assembly. Ensure the

Spark Electrode Assembly complies with the guidelines in

section 23.0 of this install manual.

If using Natural Gas, remember to re-attach the burner collar taken from the replaced

burners and pictured above.

Step 6: Replace the firebox by reversing the instructions in section 17.0 of this manual (do

not replace the glass yet).

NG LPG

Rear Log Retainer

IB600 & IB850

IB1100

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Comments to this Manuals

No comments

Escea IB600 Installation Manual Page 28

Comments to this Manuals

Related products and manuals for Fireplaces Escea IB600