Escea IB600 Installation Manual download pdf (Page 40)

630184_1 IB Service Manual NZ

Red auxiliary

Button

Replacing a Wireless Control:

If the wireless control becomes lost or damaged, a new one can be ordered from any Escea

retail agent.

When you have the new remote, the following procedure needs to be followed to “teach” the

remote to only communicate with that fire.

1. Ensure the fire and remote are set to “Off” (only the time is displayed on the remote).

2. Press the – (minus), + (plus) and the Fan Boost buttons simultaneously

until all the characters on the display light up. This will put the remote into

test mode and the two large temperature digits should be reading 00.

3. Press and hold the – (minus) button until the two large temperature digits

reading 00 start to flash slowly. Release the – (minus) button. The remote

control is now ready to be addressed to the fire.

4. Press and hold the red auxiliary on/off button

on the fireplace for a minimum of eight seconds,

or until the two large temperature digits

start counting upwards from 00 to 99

repeatedly.

Note: Pressing the red auxiliary button

on/off button will start the fire. Once the

remote control is counting the fire can be

turned off by pressing the red auxiliary

button again.

5. Press the large power button in the

middle of the remote control to exit the test

mode and return to normal operation. The

remote should only be displaying the time.

Check the fire will start using the remote

control by pressing the large power button.

Turn it off again using the remote control.

6. The fire is now re-addressed to the remote control.

Red auxiliary

button.

SET

FAN

BOOST

SET TIME

FLAME

EFFECT

ONLY

IB600 IB850 & IB1100

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Escea IB600 Installation Manual Page 40

Comments to this Manuals

Related products and manuals for Fireplaces Escea IB600